Very confused here and not a hugely experienced IT person.
I decided to lean out the dust from inside my Alieware Aurora R3 today and so disconnected my hardrives (2 1tb drives in Raid 0) before putting them back after removing the dust. However I must have either connected the Sata cables to the wrong drives or put one in the wrong place or something, because now I can get past the boot screen on the computer :(
I have tried every combination of wires and putting them in this way or the other but still I get the Alienware bios boot screen, then it shows me the Intel information screen followed by a black screen with a cursor for a second...then just blank. THe computer continues to make noise but instantly turns off by pressing the shutdown button on the front.
What am I doing wrong here or what have I done wrong :/
Any help appreciated!!
I decided to lean out the dust from inside my Alieware Aurora R3 today and so disconnected my hardrives (2 1tb drives in Raid 0) before putting them back after removing the dust. However I must have either connected the Sata cables to the wrong drives or put one in the wrong place or something, because now I can get past the boot screen on the computer :(
I have tried every combination of wires and putting them in this way or the other but still I get the Alienware bios boot screen, then it shows me the Intel information screen followed by a black screen with a cursor for a second...then just blank. THe computer continues to make noise but instantly turns off by pressing the shutdown button on the front.
What am I doing wrong here or what have I done wrong :/
Any help appreciated!!